New Page 1

OIL HEAT CONTRACTS

Detailed List of Covered Parts & Labor

We will:

1.) Test and check all oil burner safety controls,

2.) Clean or replace oil filters or strainers,

3.) Clean nozzle assembly and change nozzle,

4.) Clean and adjust ignition system,

5.) Inspect and vacuum smoke pipe and boiler (or furnace),

6.) Lubricate motors and bearing assemblies,

7.) Visually inspect wiring where possible,

8.) Perform a combustion efficiency test for maximum performance.

We will replace, if necessary:

* Air Filter

* Fuel Pump

* Aquastat

* Gauge

* Blower & Shaft Assembly

* Oil Burner Valve

* Blower Belt

* Oil Filter (cartridge)

* Blower Motor (up to 3/4hp)

* Oil Filter (complete)

* Pressure reducing valve

* Back flow valve

* Boiler drain

* Circulator & associated parts

* Circulator relays

* Burner Coupling

* Oil Tank Gauge

* Burner Fan

* Pump Strainer

* Burner Motor

* Nozzle

* Cad cell assembly

* Pressuretrol (Steam)

* Delay oil valve

* Primary Control

* Mixing Valve

* Zone Valves

* Flo Checks

* Hyvent

* Draft Regulator

* Smoke Pipe

* Draft Tube Assembly

* Stair & Burner Toggle Switch

* Fan and Limit Switch

* Standard Thermostat

* Vent Alarm & Gauge Combination

* Tank Valve

* Vent Alarm

* Transformer

* Flange Gaskets

* Relief Valves (boiler and domestic)

* Expansion tank

* Low water cut off

(First two zones only, each additional zone is $30.00 more)

872-2714 1-800-464-2714 626-2714
Winslow Manchester

All existing systems must be inspected, prior to contract agreement.
Call our service department for your system maintenance service & inspection today!

J&S Oil, Inc. Corporate Office ~ 867 Western Avenue, Manchester, Maine 04351
Phone: 1-207-622-1609 Fax: 1-207-622-7587